ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum. New: view Recent Searches.
New: visit Schematic Hell!
The sunn still shines online!

 
Listen to great tunes streaming live right now!

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  

stacked tapped parallel??


 
7/22/2003 1:33 AM
dave////irongater stacked tapped parallel??
Probably everyone here is familiar with stacked humbuckers; this would be similar but for a single coil sound. Supposedly double wrapped pickups like Seymour hots is pretty unsatisfactory due to the inside wrap being over shielded. How 'bout a stacked single (let's say a tele bridge PU) wound to stock, a thin divider over the poles, and a second wrap directly under (or over)the 1st for a overwound sound. Any thoughts?
 
7/23/2003 2:59 PM
dave////irongater
nobody??
 
 
  Tuesday
Book Of The Day The Ultimate Tone, Volume III by Kevin O'Connor
Have you ever wondered if there is a better way to build a Bassman, Champ, Plexi, an 800, AC-30, Bulldog or Portaflex? Or you wanted to build an SVT with off-the-shelf parts? How about a master-volume amp that doesn’t change tone with the master setting? Everything you need to know is right here, including: proper grounding techniques, wiring methods, and mechanical considerations. Eighteen chapters cover the “iconic” amps everyone knows and loves, with schematics and layouts for each, along with the technical history of the product. Eyelet-board and chassis-mounted tube socket construction is used throughout, for easy servicing and modding. TUT3 is very accessible even if you cannot fully read a schematic and is a "must have" if you are going to build an amp for your self.

Note: The Ampage Archive is an Amazon Associate site. A small commission is paid to the site owner on any qualified purchase made after clicking an associate link such as the one above.
 
7/23/2003 4:48 PM
Mark Hammer
email

I think it needs a better or easier to follow description to elicit comments. At this point, I'm still not able to tell if it is different than the Kinmans or not from your depiction.
 
7/23/2003 8:40 PM
Jason Lollar
email

If you are talking about wiring it so it is not acting like a stacked humbucker, it will work, done it.  
Take a regular two bobbin PAF type humbucker, make one bobbin like what you are talking about with a split, wire the top to HB specs fill in the bottom so it makes a strat coil when added in series to the top coil, you get either a regular HB combining the top of the split bobbin with the other bobbin in the set for the HB or ground out the regular HB bobbin and add both parts of the split bobbin to make a strat coil. Extrapolate and come up with whatever.
 
7/24/2003 12:13 AM
dave////irongater
hey Jason, That's pretty close to it. Both windings would go the same way(non humbucking) main coil pretty well stock,& the other only about 2-3 K, just enough to turn it into a hot.
 
   Page 1 of 1