ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum. New: view Recent Searches.
New: visit Schematic Hell!
The sunn still shines online!

 
Listen to great tunes streaming live right now!

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  
previous: muletone Hello,I've got a JCM2000 DS... -- 5/9/2004 2:07 AM View Thread

Re: Biasing a Marshall DSL50 amp

5/10/2004 4:19 PM
PAULHRe: Biasing a Marshall DSL50 amp
The center pin is ground and the outside pins are your test points (1 ohm resistors between cathodes and ground). Marshall sets them at 45mv which is to hot in my opinion. I set them for 37mv. If you can't get above 23ma, I'd say you've got something wrong i.e. bad tubes? Keep in mind these trim pots are backwards. To raise the idle current you turn the pots ccw