ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum. New: view Recent Searches.
New: visit Schematic Hell!
The sunn still shines online!

 
Listen to great tunes streaming live right now!

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  
previous: Chris B The 6SL7's amplification factor is ... -- 8/23/2000 10:29 PM View Thread

Re: 6SL7 Vs. 6SN7

8/24/2000 8:53 PM
Doc
email
Re: 6SL7 Vs. 6SN7
The 6SL7 will have a higher signal voltage gain across it, but requires a smaller maximum input voltage to saturate it. The 6SN7, which is the all-time linear textbook triode, has a lower signal voltage gain across it, but requires a higher input voltage for the same level of output voltage that a 6SL7 can produce. But the 6SN7 can withstand a higher input signal voltage without saturating, i.e., it has more headroom. So it depends on your circuit. How much signal do your output stage grids need for full output? How much preamp voltage is available to the phase inverter input?  
 
If you had a circuit, say an old Ampeg amp, that was designed with a 6SL7 PI, and without changing anything else, you replaced the PI tube with a 6SN7, the result would most likely be a cleaner amp that didn't go as loud.  
 
You can take a tube such as a 6SL7, with an amplification factor of 70, and by selecting the biasing & load resistors, create a circuit with an actual voltage gain of, say, only 10. Not all circuits push the voltage gain figure up near the theoretical capability of the tube. You can build a 6SN7 circuit with a voltage gain of 15.