| ampage Tube Amps / Music Electronics |
For current discussions, please visit Music Electronics Forum. |
ampage archive
Vintage threads from the first ten years
Specs of Early Joe Barden Single Coils
:
 6/8/2006 12:40 PM |
|
| Owen | Specs of Early Joe Barden Single Coils Anyone know what sort of output these had, types of wire and magnets? Was it a blade magnet or polepieces? I can't find much info on them - or even when they started being produced and stopped being produced. Your expertise is much appreciated! |
|---|---|
| 6/8/2006 10:47 AM |
||
Dr. Strangelove |
Owen wrote:
The dimensions follow. Joe Barden is back in business again and you may want to contact him directly <http://www.joebarden.com> Bridge Blade: 2.375''wide, .734''@center, .0625" thick (16ga.) magnet 2.440"length x.255"wide x .175" thick probably C5 ceramic total inductance: 2.420 H @ 1 kHz 2.401 H @ 120 Hz Rdc=4.436kOhm @ 69F estimated winds per coil: 2400 winds #43 single build Note that the bridge pup blade is shorter than the magnet because the neck pup is angled for blade stagger. Neck blade: 2.125" width, .7315"@center, .0625" thick magnet 2.125" length, .222"wide .222" height probably C5 ceramic total inductance: 2.491 H @ 1 kHz 2.477 H @ l20 Hz Rdc= 4.125 kOhm @ 69F estimated winds per coil: 2475 winds #43 single build. Blades are electrically connected under the magnet by copper foil, attached to bare wire ground. -drh -- | |
|---|---|---|
| 6/8/2006 4:34 PM |
|
| Owen | Thanks Dr. Strangelove, thanks very much for the Barden specs! |
|---|---|
| Page 1 of 1 |