Tube Amps / Music Electronics
|For current discussions, please visit Music Electronics Forum.|
|4/9/2004 1:12 PM|
||Hammond Equivalent to Standard 5E3 Power Tranny?|
I'm thinking that my first 5E3 build will be a Head Version. So, what Hammond Power Tranny would come closet to a Standard 5E3?
|And now, a word from our sponsors:
|4/9/2004 7:54 PM|
273CZ 325-0-325 150ma
273DX 350-0-350 90ma
373BX 350-0-350 175ma
The typical deluxe PT is around 325-0-325 70ma with a 2 amp supply for both the 6.3 volt filament and the 5 volt filament supplies. Any of the three trannies above would do it but I like the lower voltage and higher ma of the 273CZ. Bruce could chime in here as well.
|4/9/2004 11:14 PM|
Won't that 273CZ give you about 455 DC on the plates?
|4/10/2004 2:30 AM|
hammond wall voltages are spec'd with a 115V primary, keep that in mind-
they also have models that are 275-0-275 (good for tweed deluxe with SS recto) or 300-0-300 (tube recto). those would probably work much better.
|4/10/2004 3:22 AM|
here's the information from Antique Electronic Supply on their replacement PT for the Tweed Deluxe
TRANSFORMER, POWER, FENDER REPLACEMENT, 325-0-325 V, 70 mA
Replacement for Princeton, Princeton Reverb, Champ, Vibro-Champ, and Tweed Deluxe. Equivalent to # 125P1B & #022772.
Primary: 117 volt, 60 Hz
Secondary: 325-0-325 V, 70 mA
Filament winding 1: 5 V, 2 A
Filament winding 1: 6.3 V, 2 A
|4/10/2004 3:41 AM|
a great site on the rectifier output voltages for both full wave center tapped and full wave bridge.
|4/10/2004 4:19 AM|
"Won't that 273CZ give you about 455 DC on the plates?"
Not with a 5Y3 full wave tube rectifier
|Page 1 of 7||Next>||Last Page>>|