ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum.

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  

 

My Bassman LIVES!


 :
8/14/1999 9:03 AM
Aron
My Bassman LIVES!
OK,  
 
 
 
I replaced the Power Supply caps, replaced the bias capacitor, cut the possibly leaky cap from the ground switch.  
 
 
 
I used the light bulb method R.G. recommended and turned it on.  
 
 
 
To make a long story short, it works! The 64 bassman albeit scratchy pots does work and make sound.  
 
 
 
HOWEVER,  
 
 
 
The output tube closest to the power supply transformer (leftmost from back) is glowing bright orange - too bright!  
 
 
 
The other one is relatively cool when compared....  
 
 
 
When swapped socket-wise, the one tube that glowed bright still glows very bright orange.  
 
 
 
I guess it's mismatched???  
 
 
 
Help.  
 
 
 
Aron
 
8/14/1999 9:32 AM
Aron
Re: My Bassman LIVES!/Glowing tube
I noticed that it takes a minute or so for the tube to start glowing bright orange. It also has a little blue in there as well...  
 
 
 
Why would only one tube out of 2 glow so bright?  
 
 
 
Thanks,  
 
 
 
Aron
 
8/14/1999 11:58 AM
MKB

Hi, Aron. I would guess that the glowing tube is bad. If you had a screen resistor out, any tube plugged into the wrong socket would go orange. Probably the same if the bias wasn't getting to one socket. If the glow stays with a particular tube, safe bet that it is bad. Maybe try another one in its place? All this assumes the bad tube is a power tube.
 
8/14/1999 5:45 PM
Aron
Re: My Bassman LIVES!/bad ?Glowing tube
Thank you!  
 
 
 
I guess the tube is bad. It's the original 5881 tube. Yes it is the power tube. Moving it to the other socket doesn't change a thing - no matter where it is, it glows too bright.  
 
 
 
Aron
 
8/18/1999 8:58 AM
Aron
Re: My Bassman LIVES!
Yes it was the tube.  
 
 
 
My friend sent me some GE and Sylvania tubes and I ended up using the Sylvania tubes. They work fine.  
 
 
 
 
8/18/1999 1:53 PM
Gus
Leaky coupling cap change both to the output tubes better tube can take it but you should still change both.
 
8/18/1999 5:40 PM
Aron

Which caps are you talking about Gus? I'm not sure...  
 
 
 
http://www.geocities.com/Area51/Nova/4551/schems/bassman_6g6-b_schem.gif  
 
 
 
Can you point them out to me on the schematic?  
 
 
 
Thanks,  
 
 
 
Aron
 

  Page 1 of 2 Next> Last Page>>