Schemtaic wanted -- Bass cut for guitar...

 :

5/8/1999 5:37 PM
David Manson	Schemtaic wanted -- Bass cut for guitar... Does anyone know a good way to wire a bass control for the guitar (passive) -- i've tried caps in series with the signal but it isnt very effective,,, usually cuts the mids as well...     Dave

 

5/11/1999 8:40 AM
nic	bass cuts tend to cut mids as well.

 

5/11/1999 1:26 PM
David Manson	G&L guitars have bass cuts.. anyone have on to look inside? just interested in how its wired.. thanks..

 

5/11/1999 2:06 PM

Doc

Re: Schemtaic wanted -- Bass cut for guitar... Simple 2-component rolloff networks, with a single cap & resistor, tend to have a pretty lazy 6db/ octave attenuation rate. This is extremely gradual. Using such a gradual attenuation curve for a low frequency cutoff will have noticeable attenuation in the mid voice. You can achieve steeper sloped rolloffs close to a chosen corner frequency with a series of these networks, but could introduce unwanted signal loss and phase shift.     One way to reduce the low end output of the pickups is to lower the height adjustment on that end of the pickup, but leave the treble end high.

 

5/11/1999 1:27 PM
Gus	look a http://www.guitarsbyleo.com there is a schematic of the s500 controls vol,bass,treble     Gus

 

5/11/1999 1:54 PM
Doc	Gus:     There's a lot of great information over at that G&L site, especially about pickups, but I wasn't able to locate that schematic. What category needs to be selected to get there?     Thanks,   Doc

 

5/11/1999 2:30 PM
Gus	pictures     92LEGPTB.GIF

 

Page 1 of 2

Next>

Last Page>>