Rob OT design -- 4/20/1999 10:45 PM
   SpeedRacer RG or Stephen can give a far more d... -- 4/21/1999 6:46 AM
   R.G. Each set of laminations has what th... -- 4/21/1999 6:55 AM
   Bob S Rob,Now I'm confused. I've been wor... -- 4/21/1999 9:13 AM
      R.G. Good point, Bob. I was focusing on ... -- 4/21/1999 3:09 PM
         Rob 4k p-p makes it a lot easier - I wo... -- 4/21/1999 7:11 PM
            R.G. That's really the problem. You may ... -- 4/22/1999 8:03 AM
            Bob S I don't know very much about this, ... -- 4/22/1999 8:37 AM
               SpeedRacer Do you know which scale he's referr... -- 4/22/1999 11:30 AM
               R.G. I'd have to know more about what th... -- 4/22/1999 12:21 PM
                  Bob S I believe it has to do with the all... -- 4/23/1999 10:10 AM
                  SpeedRacer The "M" scale is an ASTM scale that... -- 4/24/1999 9:25 PM
                     SpeedRacer ..getting some dissention in the tr... -- 4/26/1999 11:09 AM
                        R.G. Lamination availablity -- 4/26/1999 2:16 PM
                           SpeedRacer I am in the process of digging deep... -- 4/26/1999 7:57 PM
                              Doc Sometimes, ASTM specs "expire", and... -- 4/27/1999 9:32 AM
                              Doc Speed:What spec number are you look... -- 4/27/1999 10:20 AM
                                 SpeedRacer Great post! Thx!fwiw: A346 was the... -- 4/27/1999 11:34 AM
                                    Doc The A345 I have says that grain ori... -- 4/27/1999 2:19 PM
                                       SpeedRacer Thanks Doc! I'll look him up. I'm g... -- 4/27/1999 3:39 PM
                                          R.G. You're being seduced by the dark si... -- 4/27/1999 6:48 PM
                                             Don Symes Better that than the hot end of _an... -- 4/28/1999 8:18 AM