ampage
Tube Amps / Music Electronics		 For current discussions, please visit Music Electronics Forum.

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  

 

previous: Tony@Mastertone WolfeIf my mind serves me c... -- 9/6/2002 8:11 AM view thread

Re: Bobbin/wire shift

9/6/2002 10:43 AM
Greg Simon
Re: Bobbin/wire shift
That makes a lot of sense Tony. If the drill press is on its side, its probably not exactly at 90 degrees. I don't remember since its been a couple years since I saw it firsthand, but I don't think Wolfe had anything supporting the head end of the press to make sure it was 90 degrees. You should check it out Wolfe! Could be an easy solution!  
Greg Simon