ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum. New: view Recent Searches.
New: visit Schematic Hell!
The sunn still shines online!

 
Listen to great tunes streaming live right now!

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  
previous: Major Pain Hey Don,Grab 3 1-ohm 1/2-wa... -- 11/17/2003 2:59 AM View Thread

Re: ?

11/18/2003 1:56 AM
Don Symes
email
Re: ?
1 Stack 3 resistors together.  
 
2 Wrap the 3 leads on one end together and solder.  
 
3 Wrap up the 3 leads on the other end and solder.  
 
Repeat 1-3 to make a second set.  
 
a Unsolder a heater wire from the first tube they hit.  
 
b Slip a bit of heatshrink tubing over the wire. Trim the resistor leads to a convenient length and solder to the tube pin you just took the wire off of.  
 
c Solder the wire to the other resistor leads. Shrink the tubing to insulate that junction.  
 
Repeat a-c for the other heater wire to that same tube.

 
Replies:
Major Pain Re: Thanks Don -- 11/18/2003 3:16 AM