ampage Tube Amps / Music Electronics	For current discussions, please visit Music Electronics Forum.

ampage archive

Vintage threads from the first ten years

previous: Shon That is a wonderfull solution! It's... -- 4/17/2000 1:02 AM

Re: Using Pre Amp Outs

4/17/2000 3:30 AM
dale	Re: Using Pre Amp Outs shon, you could solder it internally, but these are switching jacks, so you'd also have to sperate the contacts that only open when a jack is inserted. if you dont do that the preamp signal will also be sent to ground and you'll have no sound from the send jack.you could either do this by phsically seperating the contacts by putting something between them like electrical tape or something, unless they are closed jacks where you can't get to them. or you could do it by seprating the connection on the circuit board by scraping at the circuit traces to create an open circuit. dale

4/17/2000 3:30 AM

dale

Re: Using Pre Amp Outs

shon,

you could solder it internally, but these are switching jacks, so you'd also have to sperate the contacts that only open when a jack is inserted. if you dont do that the preamp signal will also be sent to ground and you'll have no sound from the send jack.you could either do this by phsically seperating the contacts by putting something between them like electrical tape or something, unless they are closed jacks where you can't get to them. or you could do it by seprating the connection on the circuit board by scraping at the circuit traces to create an open circuit.

dale