ampage Tube Amps / Music Electronics	For current discussions, please visit Music Electronics Forum.

ampage archive

Vintage threads from the first ten years

previous: Gil Ayan Bruce, I believe you're referring t... -- 11/8/1999 6:47 PM

Re: Where online to buy PCB material.

11/9/1999 7:25 AM

Charles

Re: Where online to buy PCB material. Hi Guys....     Here's what I have in G10 board...     Precut strips 3.125 wide UNCLAD in .125 and .062 material.   Price is .40 and .20 per running inch in that width.     We get little waste when cutting to that width, however...     Other sizes can be made up, but it requires a whole sheet   (30x40) to be purchased.     Brians 12x12 sections came out a little on the expensive side, because of the scrap involved (could be used for other stuff I suppose).     The special cuts take about 2 weeks to get done, as I have to get it table sawed from a fellow with a diamond blade. The glass will just ruin even a carbide blade. For cross cutting the strips, I use a metal cutting hacksaw blade in the jig saw, but they dull out after just a few cuts.     I never realized this stuff was so tuff until I started cutting it!

 

Replies:

Gil Ayan WEll, I am one of Charles' satisfie... -- 11/9/1999 5:27 PM