ampage
Tube Amps / Music Electronics		 For current discussions, please visit Music Electronics Forum.

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  

 

previous: Aron I've been measuring my bias current... -- 8/25/1999 5:18 PM view thread

Re: Bias set too low?

8/25/1999 6:13 PM
Carlo
Re: Bias set too low?
quote:
""I have not put the 1ohm resistors to ground so I can measure my current draw (need a stronger iron)""
 
 
 
 
Since pin 8 is already connected to chassis ground, you can avoid having to solder directly to the chassis. Just disconnect the wire from pin 8 and leave the other end still attached to the chassis. Then solder one end of the 1 ohm resistor to the wire and the other end to pin 8.  
 
Hope this helps.

 
Replies:
Aron In the back of my mind I knew I cou... -- 8/25/1999 6:21 PM