ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum. New: visit Schematic Hell!
 
The sunn still shines online!

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  
previous: Ray Ivers John,You can multip... -- 7/11/2000 1:09 AM View Thread

Re: humble clone

7/11/2000 1:59 AM
Steve Ahola
Re: humble clone
Ray:  
 
    The presence control on many Humble clones is a bit weird... I just barely crack it open and it sounds like a "regular" pc set to 4 or 5... If I turn it up to 4 or 5 the sound is way too bright.  
 
    On the design I used the feedback resistor is 4k7, the presense control is 2k, the cap is a 1.0uF tantalum and the cap and pot is bypassed with a 390 ohm resistor. (The OT has a single 4 ohm tap, although I use an 8 ohm cab.)  
 
    Any suggestions on modifying the presence circuit so that a setting of 5 would be equivalent to a current setting of 1?  
 
--Thanks!  
 
Steve Ahola  
 
P.S. To the Dutch Guy... I just noticed your post last night and was going to tell you about these controls being very bright but it was time to log off... :(  
 
    BTW your English is better than many people who were born in America! I'd sure hate to have to post messages in the Spanish I studied in grade school ("Hola, Isabel! Como esta?") Good luck with your project!

 
Replies:
Ray Ivers Steve,Another aspec... -- 7/11/2000 11:58 AM
Gil Ayan Weird Report, Steve... Re: humble clone -- 7/11/2000 3:50 PM