ampage
Tube Amps / Music Electronics
For current discussions, please visit Music Electronics Forum. New: visit Schematic Hell!
 
The sunn still shines online!

ampage archive

Vintage threads from the first ten years

Search for:  Mode:  
previous: Chris Harden Thanks Ray,I should... -- 6/14/2000 1:27 PM View Thread

Re: Reverb Tanks

6/15/2000 1:45 AM
Ray Ivers
Re: Reverb Tanks
Chris,  
 
Just going from memory, I should think an LM386 (ECG823) should work to drive your pan - it's an 8-pin DIP power op-amp that puts out about 1 watt or so (approximately the proper drive level for your reverb tank); it takes +15 volts or less to power it.  
 
Your tank is 3-spring, 8 ohm input, 2250 ohm output, medium delay, input insulated/output grounded, no spring lock, horizontal open-side-down mounting. Maybe you knew all this info already.  
 
Hope this helps!  
 
Ray

 
Replies:
Chris Harden Ray,Thanks, for som... -- 6/18/2000 10:26 AM