previous: chuck built it off of rg's board using mp... -- 6/12/2000 10:36 PM

Re: Problems w/ mini booster 2....help please

6/12/2000 11:42 PM

aron

Re: Problems w/ mini booster 2....help please Chuck, It sounds like you have it close to working. Are there trimmers in the booster 2? Anyway, if this is the booster 2 that I am thinking about, read this note: "The top two wires coming out of the board on the left should be swapped. The first one should go to the DPDT as it's the input of the board. The 2nd should go to the GROUND of the input jack - check out the board - the leftmost wire goes to a 1M resistor to ground (anti-pop resistor), the 2nd one goes straight to ground." You need to swap the left top two wires as described. I think R.G. was going to update the .pdf. Aron

 

Replies:

R.G. q{You need to swap the left top two... -- 6/13/2000 2:47 AM