Problems w/ mini booster 2....help please

6/12/2000 10:36 PM

chuck

Problems w/ mini booster 2....help please built it off of rg's board using mpf102's and nte458's. i caught the different pinout on the nte458's so i don't think thats the problem (they end up mounting at 45dg. angle instead of 90) i used a 3pdt switch w/ led and used the schematic wireing diagram instead of layout (for mill. bypass). the light comes on, and the board is getting power, but there is no sound whatsoever comeing out of it. the only sound i can get out of it is by turning the trimmers inside i get the scratchy pot sound. works fine in bypass mode. measured D and G on the jfets and they have 4v and 6v going tru each one (if that means anything). ive triple checked the wireing, cap polarity, etc. heated up any questionable connections. anyone have any ideas?   thanks for your help!!   chuck