ampage Tube Amps / Music Electronics	For current discussions, please visit Music Electronics Forum.

ampage archive

Vintage threads from the first ten years

previous: Gus One thing you can try that takes al... -- 5/17/2000 8:24 PM

Re: Washburn WRB-46

5/18/2000 1:52 PM
Graywater	Re: Washburn WRB-46 Gus, Thanks for your follow-up reply - this is a single side single board design and I did a quick solder pad inspection/remelt. I make part of my living repairing guitar amps, etc., and I have to determine when a piece of equipment will absorb more time than my bench fee reimburses me for and this unit is at the stage that only the presence of a schematic would justify more time. Unfortunately, this is too often true with effects and this is why I don't fool with them (took about 15 minutes to remove all of the screws, jacks, knobs, etc. just to get at the foil side of the circuit board). Again, appreciate your help. GW

5/18/2000 1:52 PM

Graywater

Re: Washburn WRB-46

Gus,

Thanks for your follow-up reply - this is a single side single board design and I did a quick solder pad inspection/remelt. I make part of my living repairing guitar amps, etc., and I have to determine when a piece of equipment will absorb more time than my bench fee reimburses me for and this unit is at the stage that only the presence of a schematic would justify more time. Unfortunately, this is too often true with effects and this is why I don't fool with them (took about 15 minutes to remove all of the screws, jacks, knobs, etc. just to get at the foil side of the circuit board).

Again, appreciate your help.

GW