Tube Amps / Music Electronics
|For current discussions, please visit Music Electronics Forum.||New: view Recent Searches.
New: visit Schematic Hell!
The sunn still shines online!
|Listen to great tunes streaming live right now!|
|8/5/1999 2:51 AM|
|R.G.||How to match FETs in a phaser?|
Rob (firstname.lastname@example.org) asked:
What's being matched is the voltage between gate and source for a specific drain/source resistance. The JFETs in a phaser are all fed identical gate-source voltages from the biasing arrangement and the LFO. The drain source resistance that is controlled by that voltage is what causes the phasing. If some FETs are full on (low resistance) while others are full off (high resistance) while others are in the moderate resistance region, the ones that are full on or off are not contributing to the phasing.
The D-S resistances don't have to be identical, but they do have to be close enough that all stages contribute to the phasing. I have made up matched sets of four and eight with the matching fixture shown. These were subbed into an MXR P90 and did sound good there, so it works.
Another gotcha in the 9V powered ones like the P90 is that there isn't much voltage there to drive the JFET gates, so the JFETs have to have a low threshold voltage. Some JFETs have threshold voltages as high as 5-9V, so they can never work properly in a 9V circuit. The original P90 devices were 2N5292, which were especially low Vgsth. 2N5484 and 2N5485 work if you select properly.
I bought a batch of 100 to make up my sets and got a number of sets out of that. I still have some if you're interested.
There aren't any that are both good and easy, near as I can tell. The MXR micro chorus is close. I keep intending to do a flanger/chorus PCB, just haven't had time.